Hamilube® 7709 – Cutting Oil

Hamilube® 7709 is a non-chlorinated straight oil containing friction-reducing extreme pressure additives, which makes it suitable for drilling operations. It is also applicable for threading, tapping, turning, milling, trepanning and other machining operations on steel. Used on Stainless and Alloyed steels. It contains sulfurized additives and has a light viscosity, which makes it suitable for gun drilling. It will provide an adequate fluid film between the wear pads and the work material, will prevent welding of chips to the cutting edge of the drill, will cool the drill and the work, and dispose of the chips easily by flushing.

Hamilube® 7609 – Cutting Oil

Hamilube® 7609 is a low viscosity straight oil containing friction-reducing extreme pressure additives, which makes it suitable for drilling operations. It is also applicable for threading, tapping, turning, milling, trepanning and other machining operations on steel. A combination of extreme pressure additives, along with its light viscosity, makes it suitable for gun drilling. It will provide an adequate fluid film between the wear pads and the work material, will prevent welding of chips to the cutting edge of the drill, will cool the drill and the work, and dispose of the chips easily by flushing.

Hamilube® 5705 – Cutting Oil

Hamilube® 5705 is a straight oil containing extreme pressure additives for the general machining of tool steel and stainless steel. It contains no chlorinated compounds, phosphorus or animal fats. Not suitable for use with non-ferrous metals.

Hamilube® 1744 – Cutting Oil

Hamilube® 1744 is a straight oil containing extreme pressure additives for general machining of all metals, including Magnesium.

Hamilube® 1328-N – Cutting Oil

Hamilube® 1328-N contains no chlorinated compounds and only minimal amounts of sulfur and phosphorus. It has a light viscosity to flush away metal chips and provide efficient heat removal from the work and tooling. It is suitable for machining operations such as trepanning, threading, tapping, turning, milling and drilling of steel.

Hamico® 863-EP

Hamico® 863-EP Base is normally used as received, but can be diluted with oil, solvents, or water, depending on the operation. It may be applied by dipping, spray, or brushing. It is a combination of extreme pressure lubricants. It is used either neat or with oil. It is used primarily for tapping operations on steel. It will not corrode steel or aluminum on contact, but will stain brass and copper.